hello! recently downloaded the 200GB Nostalgia image for pi4. used SD formatter to format a Samsung 256GB SD card. then used Etcher to burn image to the SD card. put in card in Pi4 and powered up the unit. i only get to the boot screen and wont get further. im new to this raspberry stuff and not very familiar with linux at all. but in the noot screen the part that stood out was:

start4.elf is not compatible 0x0

and below that:

This board requires newer software
https://www.raspberrypi.org/downloads

(apologizes didnt know how to post image here) any help is greatly appreciated! many thanks in advance!