Its here, the image y’all been waiting for , for a VERY long time – FINALLY Its now time to boot up COINOPS LEGENDS 2 on your Raspberry Pi 4 – thanks to everyone at the CoinOps Project and of course the guys who ported the ‘nix edition over, specifically Andyburn, Bluestang and EliasBlizzard – THANK YOU TO ALL!
This is TINY in size and should EASILY fit on ANY , real, Micro SD Card, however it is recommended (for performance speeds) to be written to a SSD or NVME – This is a high resource build!
From the Devs:-
Only one we found is using a KB for retrofe navigation – a fix will be issued at some point.
Use a controller as mentioned below.
The image will AUTO-EXPAND the partition on first boot to fill the disk.
It will then REBOOT without warning, adn then proceed to start CoinOPS.
Sound is over HDMI by default.
You can log in over ssh with user:pi, pass:arcade and run sudo raspi-config to change stuff.
Use a xinput controller only.
Dinput is not supported.
Has been tested with XBOX360 controller and Logitech F310
Other controllers may be supported in the future – this is a first release!!
Title =”CoinOPS Pi4 Legends 2 V1.0”