In this video, I take a look at the all new Raspberry Pi 3 A+ !
I also go over specs and test out RetroPie on this slimmed down Pi3.
The Pi foundation has a new Raspberry Pi! It’s not the Pi 4 “Yet” but its still an awesome addition to the pi family!
How to update your pi3b/+ stretch image to work on the new pi3a+
Put your sd card into your pi3b and go into the terminal. Type:
sudo apt-get update && sudo apt-get -y upgrade
After that is done go into raspi-config and make these changes.
In advanced options
Memory split = 348
And in boot options make it
Auto login into console
Let it reboot an make sure it boots into emulationstation. Then turn it off and move the sd card to the pi3a+ and turn it on.
You might need to reset the WiFi country, I didn’t but others have.
Broadcom BCM2837B0, Cortex-A53 (ARMv8) 64-bit SoC @ 1.4GHz
512MB LPDDR2 SDRAM
2.4GHz and 5GHz IEEE 802.11.b/g/n/ac wireless LAN, Bluetooth 4.2/BLE
Extended 40-pin GPIO header
Single USB 2.0 ports
CSI camera port for connecting a Raspberry Pi Camera Module
DSI display port for connecting a Raspberry Pi Touch Display
4-pole stereo output and composite video port
Micro SD port for loading your operating system and storing data
5V/2.5A DC power input0
#RaspberryPi #etaprime #retropie
Latest posts by ETA PRIME (see all)
- The ODROID N2 New Odroid SBC Announced!Amlogic S922x USB 3.0 and DDR4 - February 15, 2019
- Entry Level Laptop Emulation Test Using Batocera Linux - February 13, 2019
- RetroArch Has A New Look! New Ozone Menu Driver/Theme - February 11, 2019